Toyota Prius Brake Pad Replacement

Toyota Prius Brake Pad Replacement in Batumi

Toyota Prius brake pad replacement starts with switching off the electronically controlled brake system (ECB), otherwise it can push the pistons out while the caliper is apart. Then we clean and grease the slide pins, check that the pistons move freely and fit the new pads. PRO SERVICE, Batumi, Airport Highway 212M.

Prius pads last forever. The calipers don't.

Most of the time a Prius slows down on its motor-generator, which turns the car's speed back into battery charge. The friction brakes only step in when you brake hard and for the last few mph of a stop, roughly under 10 km/h. That's why front pads on a Prius often go past 100,000 km and owners forget the brakes exist.

Here's the catch. A caliper that barely works sits in humid, salty Black Sea air and seizes. Slide pins stick, a piston gets lazy, the pad rusts in place in its bracket. The disc grows a rust lip at the edge and the friction surface turns blotchy. We see plenty of cars with half the pad material left on one side and the other pad worn twice as fast. That's not wear. That's a stuck caliper.

Brakes by generation

GenerationFrontRearWatch for
NHW20, 2003-2009vented discsdrumsECB accumulator, foot parking brake
ZVW30, 2009-2015vented discsdiscssmall parking brake drum inside the rear rotor hat
ZVW50, 2015 onvented discsdiscsdifferent brake actuator layout, pads matched by VIN

Gen 3 and Gen 4 pads look alike but don't swap. Prius v and Prius c have their own too. We order by VIN.

When it's time

  • A squeak or scrape right at the end of a stop. On a Prius that's exactly when the pads are working, so you hear it there.
  • The car pulls under braking, especially on wet roads.
  • One wheel is much hotter than the others after a drive. Sticking piston or slide pin.
  • ABS and BRAKE lights plus the triangle, and a pump under the hood that runs for a long time. That's the brake actuator, not the pads, and it needs a scan.

On a Prius the odometer tells you very little. We go by pad thickness and how the slides move.

ECB off, then the pads

  1. ECB off. On Gen 2 and Gen 3 the brake pump builds pressure by itself the moment you open the driver's door or touch the pedal. With a caliper off, that pushes the piston out while your hands are right there. We set ECB Invalid with the scan tool or cut power the way the Toyota manual describes.
  2. Wheels and calipers off, pads out. We measure what's left on both inner and outer pads.
  3. Slide pins out, old grease and rust cleaned off. Torn boots get replaced.
  4. Brackets scraped to bare metal where the pads sit, new shims and clips go on.
  5. Pistons pushed back slowly while we watch the reservoir level. A piston that fights back means the caliper needs work, and we'll tell you.
  6. ECB back on, codes cleared, a few pedal presses, test drive.

On a Gen 2 we pull the rear drums. The shoes there hardly wear, but the self-adjuster seizes and wheel cylinders start to weep. On a Gen 3 we also open the parking brake drum inside the rear rotor. If those little shoes rust to the drum, the parking brake releases late and the rear wheel runs hot.

What else we check on a Prius

  • Brake fluid moisture. Flushing a Prius means bleeding with the scan tool, not opening bleeders and pumping the pedal. We quote the bleed after inspection.
  • Discs. A rust lip and blotches can come off with machining if there's thickness to spare. If not, it's disc replacement.
  • Brake actuator codes. On Gen 2 and Gen 3 the accumulator can lose pressure for months while the owner only notices a pump that hums longer than before.
  • Everything else hybrid-related is on our Toyota Prius repair page.

Price

WorkPrice, GEL
Prius pads, front axlefrom 40
Prius pads, rear axlefrom 40
Disc replacement (axle)from 60
Brake system scanfrom 30

Pads, discs and grease are extra. You can bring your own parts, but they carry no warranty. New parts we supply come with a warranty of 30 days or more from fitting, depending on the part. We can order parts for any car.

FAQ

Can you change Prius pads without disabling ECB?

Technically yes, but we don't. One press of the pedal with a caliper off and the piston comes out of its bore, and then you're replacing seals and bleeding the system.

My Gen 3 pads are thick but the brakes squeal. Why?

Usually seized slide pins or a pad rusted in the bracket. Cleaning and greasing fixes the noise. New pads aren't always needed for that.

How long do Prius brake pads last?

Fronts often go past 100,000 km. Rears vary a lot. Go by pad thickness and caliper condition, not mileage.

Why is there a brake warning after a pad change?

The system was opened without being switched off, or the codes weren't cleared afterward. We plug in the scan tool and read what the module stored.

Do you replace the Prius brake accumulator or actuator?

First a scan from 30 GEL to read pressure and codes. You get the plan and the estimate after that.

●  06 · Contact

Leave a request — we'll call back and book an inspection

Tell us what happened to the car. We'll call back, answer your questions and find a time. We give the exact price after an inspection: photos don't always show the damage.

By sending the request you accept the privacy policy.

Or message us — we reply right there:

Address
Airport Highway 212M, Batumi, Georgia
Phone / WhatsApp / Telegram
+995 599 66 66 75 · WhatsApp · Telegram
Directions
Google Maps ↗Yandex ↗Waze ↗
PRO SERVICE entrance