Toyota Prius Coolant Change in Batumi
A Toyota Prius coolant change in Batumi covers two loops that never mix: one cools the gas engine, the other the inverter and electric motors, each with its own reservoir, pump and schedule. PRO SERVICE, Airport Highway 212M. Engine loop with bleeding from 40 GEL.
What each generation has
| Body | Engine | Engine water pump | Worth knowing |
|---|---|---|---|
| NHW20, 2003-2009 | 1NZ-FXE | mechanical, belt driven | coolant heat storage tank with its own pump |
| ZVW30, 2009-2015 | 2ZR-FXE | electric, no belt | uses exhaust heat to warm up faster |
| ZVW50, 2015-2022 | 2ZR-FXE | electric | two loops, same idea as the 30 |
The Gen 2 car has one part that catches out even shops that have done a hundred Priuses: the heat storage tank. It's a steel thermos that stores hot coolant when you switch off, so the engine warms up quicker next time. It keeps that coolant hot for a very long time, days rather than hours. Open its drain on a car that sat overnight and you get boiling water on your hands. We drain it too during a change. Skip it and a good part of the old coolant ends up back in the system.
What goes in
Toyota Super Long Life Coolant, the pink one, premixed 50/50. Both loops take the same fluid. We don't use green universal stuff or the red G12 types from auto shops. Mixed chemistries can drop sludge, and the inverter passages are narrow. Toyota's schedule for SLLC is roughly a first change at 160,000 km or 10 years, then about every 80,000 km or 5 years. On a car from a US auction with no history, we look at the color and smell and decide from there.
Signs the Prius coolant is due
- The coolant has gone brown or cloudy, with a crust inside the reservoir.
- Water in the inverter reservoir, or fluid in a clearly different color. We see that after auction body repairs.
- Lukewarm heat in winter with the engine fully warm. Usually trapped air.
- Code P0A93 for inverter cooling. It can be the pump. It can also be air or dirt after a botched change somewhere else.
- The level keeps dropping and nothing drips. On the 2ZR-FXE we look at the EGR cooler and the head gasket.
Draining and bleeding, step by step
- The car cools down first. On a Gen 2 we check the storage tank temperature separately.
- Scan tool on: engine and inverter temperatures, stored codes.
- Engine loop drained through the radiator cock and the block plug. On the NHW20, the thermos too.
- If the old fluid came out dirty, we flush with distilled water and drain again.
- Fresh SLLC in, then the air comes out. On the 30 and 50 the scan tool runs the electric water pump while the engine sits in maintenance mode and the heater is on full. Skip that and the electric pump can spin in an air pocket, and the engine overheats out of nowhere.
- The inverter loop is a separate job, done by mileage or condition. After filling we put the car in READY, watch the fluid move in its reservoir and top up.
- Short drive, then levels checked again cold. Give it another look in a couple of days, small bubbles take time to work out.
Caps, hoses and radiator fins
Radiator and reservoir caps, hoses and clamps. The radiator fins: close to the sea they fill with sand and salt, and in summer traffic on Chavchavadze Street the fan barely stops. Both cooling fans. Hybrid system weak spots like the inverter pump and EGR are on our Toyota Prius repair page.
Price
| Work | Price, GEL |
|---|---|
| Engine loop change with bleeding | from 40 |
| Electric engine water pump or inverter pump replacement | from 60 |
| Temperatures and codes by scan tool | from 30 |
Inverter loop change as a separate job is quoted after inspection. You can bring your own parts, but they carry no warranty. New parts we supply come with a warranty of 30 days or more from fitting, depending on the part. We can order parts for any car.
FAQ
I can't find pink coolant. Can I top up with regular antifreeze?
On the road, distilled water is the better stopgap, then a proper change. A mix of different coolants means a flush later.
Should both loops be done at once?
If both are due, or the car's history is unknown, yes. If the inverter fluid is fresh and clean, we do the engine side only.
The heater stopped working after a coolant change at another shop. Why?
Almost always air. We hook up the scan tool, run the pump and bleed it again.
Is the Gen 2 coolant really still hot in the morning?
Yes, the thermos holds heat for a long time. We only drain it after measuring the temperature.
● 06 · Contact
Leave a request — we'll call back and book an inspection
Tell us what happened to the car. We'll call back, answer your questions and find a time. We give the exact price after an inspection: photos don't always show the damage.
By sending the request you accept the privacy policy.
Or message us — we reply right there:
- Address
- Airport Highway 212M, Batumi, Georgia
- Phone / WhatsApp / Telegram
- +995 599 66 66 75 · WhatsApp · Telegram
- Directions
- Google Maps ↗Yandex ↗Waze ↗
