Head Gasket Repair Shop in Batumi

Head Gasket Repair Shop in Batumi

If you need a head gasket repair shop near you in Batumi, PRO SERVICE is on Airport Highway 212M. We confirm the gasket has failed with proper tests, pull the cylinder head, check it's flat and fit a new gasket and bolts. Oil and coolant are changed as part of the job. Labor from 250 GEL, takes 1-2 working days. Keep driving on a blown gasket and you risk overheating that warps the head or finishes the engine.

Signs of a blown head gasket

  • The coolant level drops but there's no leak you can see.
  • Thick, sweet-smelling white smoke that doesn't go away once the engine is warm.
  • Milky sludge under the oil filler cap and on the dipstick.
  • Bubbles in the expansion tank, or coolant being pushed out of it. The hoses go rock-hard with the engine running.
  • It overheats on climbs or in traffic, and the temperature needle won't sit still.
  • Oil or soot along the joint between the block and the head.

A cracked head or a failed oil cooler can show some of the same signs. So before anything comes apart we run a combustion gas (block) test on the coolant, pressure-test the cooling system and check compression on every cylinder.

Why head gaskets fail

Nine times out of ten it's overheating. The radiator is clogged, the thermostat, pump or fan has quit, or coolant is leaking somewhere. Batumi's summer heat and traffic only add to it. If you replace the gasket and ignore the cause, it'll blow again, so we go through the whole cooling system and fix whatever is wrong.

How we replace it

  1. Drain the fluids, take off the accessories and the timing drive, then lift the head.
  2. Clean the mating surfaces and check the head for warping and cracks.
  3. If flatness is out of tolerance, the head needs resurfacing, and the job becomes a cylinder head repair.
  4. New gasket and new head bolts, since on most engines the bolts are single-use. They're tightened in sequence to the manufacturer's torque.
  5. Reassembly, fresh coolant, an oil change to get rid of the emulsion, and bleeding out the air.
  6. We warm it up, pressure-check the cooling system and test the tank for exhaust gas.

For the first few weeks, keep an eye on your coolant and oil. If either level drops, come back before it has a chance to overheat.

What affects the cost

The layout of the engine matters: transverse or longitudinal, inline or V (a V has two gaskets). Then there's whether the head needs resurfacing or new valves. Some owners also do the timing belt or chain at the same time, because access is already open.

Price

WorkPrice, GEL
Head gasket replacement (labor)from 250
Cylinder head repair if warpedfrom 300
Coolant changefrom 40
Oil changefrom 30

FAQ

Can I keep driving with a blown head gasket?

Only for a short distance, and only to the shop. Coolant in the oil destroys the bearings, overheating warps the head, and the bill keeps growing.

Do radiator sealants help?

Sometimes, as a stopgap. They also clog the radiator and heater core, and they're no substitute for a new gasket.

How much does head gasket replacement cost?

Labor from 250 GEL. The gasket set, bolts and fluids are extra and vary by model.

Why did my head gasket blow again?

Usually because whatever caused the overheating was never fixed, or the head went back on warped. We check both.

How long will it take?

1-2 working days. Resurfacing the head adds to that.

●  06 · Contact

Leave a request — we'll call back and book an inspection

Tell us what happened to the car. We'll call back, answer your questions and find a time. We give the exact price after an inspection: photos don't always show the damage.

By sending the request you accept the privacy policy.

Or message us — we reply right there:

Address
Airport Highway 212M, Batumi, Georgia
Phone / WhatsApp / Telegram
+995 599 66 66 75 · WhatsApp · Telegram
Directions
Google Maps ↗Yandex ↗Waze ↗
PRO SERVICE entrance