Brake Disc Machining in Batumi
Brake disc machining at PRO SERVICE (Batumi, Airport Highway 212M): we skim a thin layer off the braking surface to get rid of runout, grooves and the lip at the edge. Price from 70 GEL per axle, takes 1-2 hours. Thickness gets measured first, and if the disc would end up under the minimum, we'll recommend disc replacement instead.
When machining makes sense
- The pedal or steering wheel pulses when you brake, yet the disc still has plenty of thickness. Typical after the brakes overheat on long descents.
- The braking surface is uneven, with light grooves or a lip at the edge.
- Rust patches from the car standing a long time that braking didn't wear off.
- You're putting new pads on discs with enough thickness left and want them to bed in evenly.
When machining will not help
If the disc is already close to its minimum thickness (stamped "MIN TH" on the disc, or in the manufacturer's data), cutting it would take it out of spec. Cracks, blue heat spots and deep rust pitting rule it out as well. On an inexpensive model with a thin solid disc, machining can cost about as much as a new one.
And sometimes the disc isn't the problem at all. A dirty or bent hub or a worn wheel bearing can cause the runout, and machining just masks the symptom for a while before it comes back.
How we do it
- Before touching anything, we measure thickness with a micrometer and runout with a dial gauge.
- The hub and wheel bearing are checked so we know where the runout is coming from.
- We machine the disc flat, on the car or off it depending on the equipment, taking off as little metal as we can.
- Thickness and runout are measured again.
- Everything goes back together, usually with new pads. We lube the caliper slide pins and take it for a test drive.
Worth knowing
A machined disc is thinner. It holds less heat and gets hot faster when you brake hard. Machining gives you a flat surface back, not the lost thickness, so a disc normally can't be machined a second time. The next step after that is replacement.
Where runout comes from
Overheating, most of the time. You ride the brakes down a long hill, stop hard at the bottom and sit there holding the pedal. The hot disc cools unevenly and pad material gets printed onto it. Use engine braking on descents, and have the wheel bolts tightened to the manufacturer's torque with a torque wrench instead of an impact gun.
Prices
| Service | Price, GEL |
|---|---|
| Brake disc machining (axle) | from 70 |
| Brake disc replacement (axle) | from 60 |
| Brake pad replacement (axle) | from 40 |
FAQ
Which is better: machining or replacement?
With thickness to spare and no cracks, machining is the cheaper option. If the disc is near the minimum or keeps warping, replace it.
Do I need new pads after machining?
Usually yes. Old pads have worn to the shape of the old surface and won't seat properly.
Why did the pulsation come back after machining?
Often because the disc was never the cause. Dirt on the hub, over-tightened wheel bolts and overheating can all do it, and we check for them before starting.
How long does it take?
1-2 hours per axle.
● 06 · Contact
Leave a request — we'll call back and book an inspection
Tell us what happened to the car. We'll call back, answer your questions and find a time. We give the exact price after an inspection: photos don't always show the damage.
By sending the request you accept the privacy policy.
Or message us — we reply right there:
- Address
- Airport Highway 212M, Batumi, Georgia
- Phone / WhatsApp / Telegram
- +995 599 66 66 75 · WhatsApp · Telegram
- Directions
- Google Maps ↗Yandex ↗Waze ↗
