Wheel Bearing Replacement in Batumi
Wheel bearing replacement at PRO SERVICE (Batumi, Airport Highway 212M): first we find out exactly which wheel is humming. Then, depending on how your car is built, we either press in a new bearing or swap the complete hub unit. Labor from 80 GEL per wheel, takes 1-3 hours.
Signs of wear
- A hum or whine that climbs with speed. It sounds like tire noise, except it doesn't change when the road surface does.
- The note changes in corners, getting louder when the worn bearing takes the load.
- The wheel has play when you rock it top and bottom.
- It spins with a rumble or unevenly.
- An ABS warning light. On many cars the speed sensor reads a magnetic ring on the bearing, so a worn bearing throws faults.
Why it is important not to confuse it
It's easy to take a bearing hum for tire noise, especially when the tread is cupped or feathered. Clicking in turns, on the other hand, is usually the CV joint and not the hub. That's why we diagnose first: a test drive, a check on the lift and, if needed, listening to the wheels while they spin. Only what's actually worn gets replaced.
Design types
- Separate bearing, pressed into the steering knuckle. The knuckle has to come off and go in a press, but the bearing itself is cheaper.
- A hub unit combines the bearing, the flange and often the ABS ring in one piece that bolts on. Quicker to fit, pricier to buy.
- Some cars have the rear bearing inside the drum or the hub, and the designs vary a lot.
Wheel bearings are usually replaced one at a time, since the other one on the axle may be perfectly fine. We'll show you its play and how it sounds.
How we do it
- Pin down the wheel with a test drive and a play and rotation check.
- Take off the wheel, caliper, disc, axle nut and ABS sensor.
- Press out the old bearing or unbolt the hub.
- Press in the new bearing through the correct race so the tracks don't get damaged.
- Put it all back, torque the axle nut to the manufacturer's spec, check the ABS and go for a test drive.
If the steering knuckle came off, we check the angles and do a wheel alignment if they need it.
Price
| Work | Price, GEL |
|---|---|
| Wheel bearing replacement (per wheel) | from 80 |
| Suspension inspection | from 30 |
| Wheel alignment | from 50 |
FAQ
How much does wheel bearing replacement cost?
Labor from 80 GEL per wheel. A pressed bearing and a hub unit are priced differently, and the part is extra.
How long can I drive with a humming bearing?
Not long. A faint hum gives you a little time. Once there's play, though, the bearing can overheat and seize and take the knuckle and hub with it.
Why did the bearing wear out quickly?
Pothole hits, water getting in, a bearing that was pressed in wrong, or aftermarket wheels with a different offset.
Do bearings need replacing in pairs?
No. Each one is replaced based on its own condition. We check the other side and show you what we find.
● 06 · Contact
Leave a request — we'll call back and book an inspection
Tell us what happened to the car. We'll call back, answer your questions and find a time. We give the exact price after an inspection: photos don't always show the damage.
By sending the request you accept the privacy policy.
Or message us — we reply right there:
- Address
- Airport Highway 212M, Batumi, Georgia
- Phone / WhatsApp / Telegram
- +995 599 66 66 75 · WhatsApp · Telegram
- Directions
- Google Maps ↗Yandex ↗Waze ↗
