Toyota Camry Suspension Repair in Batumi
Toyota Camry suspension repair in Batumi goes in two steps: a short drive with you and a look on the lift, then an estimate that lists each part on its own line. We work on every Camry you see around town: XV40, XV50/XV55 and XV70. PRO SERVICE, Airport Highway 212M. Suspension diagnostics start at 30 GEL, the alignment after the job at 50 GEL.
Camry suspension by generation
All three have MacPherson struts up front. The rear is where they differ, and that decides which parts we order.
| Generation | Rear layout | What we replace most |
|---|---|---|
| XV40 (2006-2011) | struts with two lateral links and a trailing rod | sway bar links, rear bushing of the front lower arm, steering rack |
| XV50/XV55 (2011-2017) | same layout as the XV40 | front strut mounts, rear sway bar links, shocks |
| XV70 (2017-2024) | double wishbone, TNGA platform | sway bar links, rear arm bushings, shocks |
The Camry is a big sedan, and the US-market SE and XSE trims come with firmer tuning and bigger wheels. On our potholes those versions pass more of the hit into the body, and the small front parts give up sooner.
Camry front end clunk over bumps and other noises
- A short, dull clunk from the front over small bumps and cobbles. Most of the time it's the sway bar links. We replace both, since left and right wear at about the same rate.
- A knock you feel right in the steering wheel, worse when the car is cold. On the XV40 that's often the rack itself, a well-known issue. Sometimes adjusting the rack guide is enough, sometimes it needs a rebuild. More on our steering rack page.
- A creak or click when you turn the wheel standing still in a parking lot. That's the strut mount bearing, and on the XV50 it gets louder after rain.
- The wheel shimmies under braking and the car pulls. We check the big rear bushing on the front lower arm. The rubber tears all the way around and the arm shifts under load.
- A thump from the back going over a speed bump. On the XV50 it's usually the rear sway bar links or the shocks, less often the lateral link bushings.
A hum that rises with speed isn't suspension. That's a wheel bearing, and we listen for it separately by spinning the wheel on the lift.
When to bring it in
Toyota doesn't give a mileage for replacing arms. We look over the Camry suspension at every service and tell you what's starting to go. In Batumi the rubber has a harder life: potholes after heavy rain, mountain roads up to Khulo and Goderdzi, and damp sea air that seizes bolts into their sleeves. Nearly every Camry here came from the US, some after a crash, and we find bent arms or links nobody noticed at purchase.
From test drive to estimate
- We drive over cobbles and a speed bump with you to hear the exact noise.
- On the lift we pry on the arms, ball joints, tie rods and rack. On the XV40 and XV50 the lower ball joint bolts to the arm and is sold on its own, so you don't buy a whole arm for it.
- The estimate splits what's unsafe now (ball joint, tie rod end) from what can wait until next visit.
- If the arm is straight, we press a new bushing into it. An arm bent by an impact gets replaced as a unit.
- Arm bolts are torqued with the car on its wheels. Rubber tightened with the car in the air is twisted and tears early.
- Then the alignment. The Camry has adjustable rear toe, and if the cam bolt is seized we free it up first instead of setting it "close enough."
What else we check on the way
CV boots and CV joints, leaks on the rack, tire wear on the inner edge. Brakes too: pads and rotor runout get a look while the wheels are off.
Price
| Work | Price, GEL |
|---|---|
| Suspension diagnostics | from 30 |
| Front lower control arm replacement | from 60 |
| Shock or strut replacement (each) | from 30 |
| Sway bar links, ball joint, strut mount | quoted after inspection |
| Wheel alignment | from 50 |
FAQ
My XV50 Camry clunks up front over small bumps. What needs replacing?
Most likely the front sway bar links. A strut mount or ball joint can sound the same, so we put it on the lift before ordering parts.
Can you replace just the ball joint without the arm?
On the XV40 and XV50, yes, it's a separate part. On the XV70 we check the part number for your specific car.
My 2010 Camry has a knocking rack. Do I need a new one?
Not necessarily. We check the rack guide and bushings first, and the knock often goes away after an adjustment or a rebuild.
Do I need an alignment after new struts?
Yes, we check it. The strut is held to the knuckle by two bolts, and the wheel angle shifts by the play in the holes.
OEM or aftermarket parts?
Your call. We'll tell you which aftermarket brands hold up. You can also bring your own parts: fine, but customer-supplied parts carry no warranty.
● 06 · Contact
Leave a request — we'll call back and book an inspection
Tell us what happened to the car. We'll call back, answer your questions and find a time. We give the exact price after an inspection: photos don't always show the damage.
By sending the request you accept the privacy policy.
Or message us — we reply right there:
- Address
- Airport Highway 212M, Batumi, Georgia
- Phone / WhatsApp / Telegram
- +995 599 66 66 75 · WhatsApp · Telegram
- Directions
- Google Maps ↗Yandex ↗Waze ↗
