Suspension Bushing Replacement in Batumi
Suspension bushing replacement at PRO SERVICE (Batumi, Airport Highway 212M): we press the old rubber-metal bushings out of the control arms, subframe or rear beam and press new ones in. Labor from 60 GEL per bushing, takes 1-3 hours. Then a wheel alignment.
What a bushing is and why it wears
It's a sleeve of rubber (or polyurethane) sandwiched between two metal shells. The bushing joins the control arm to the body and soaks up small vibrations. Over time the rubber ages from load, heat and cold, dirt and water. Here in Batumi you can add potholes, cobblestones and damp sea air to that list.
Signs of wear
- A dull knock or creak over bumps, mostly at low speed.
- The car pulls when you brake or come off the gas.
- Steering feels vague and the car doesn't track straight like it used to.
- Tires wear unevenly, because the wheel changes its angle under load.
- On inspection we see cracked or torn rubber, rubber pushed out of the shell, or an arm that moves when we lever it.
How we do it
- Inspection to find exactly which bushings are worn: front or rear, arm, subframe or rear beam.
- The arm comes off. Some cars let you change bushings in place, but the pressing usually ends up worse.
- The old bushing goes out on the press and we clean up the seat.
- The new one is pressed in facing the right way. Many bushings have voids in the rubber, so orientation matters.
- The arm goes back on, and the bolts are tightened with the car standing on its wheels.
- Wheel alignment.
Bushings or the whole arm?
When the arm is steel and in good shape and the bushings are sold separately, doing just the bushings usually costs less. A rusty or bent arm, or one with a worn ball joint that can't be replaced, is better replaced as an assembly. We'll price both for you.
Rubber or polyurethane
Polyurethane is stiffer and usually outlasts rubber, but more vibration comes through into the cabin. Rubber is what the factory fits, and it's quieter. It comes down to what you care about more. We'll tell you what's available for your model.
Price
| Work | Price, GEL |
|---|---|
| Bushing replacement (each) | from 60 |
| Control arm replacement (each) | from 60 |
| Wheel alignment | from 50 |
FAQ
How much does bushing replacement cost?
Labor from 60 GEL each. The total depends on how many there are, how hard they are to reach and whether the subframe has to come down.
Can I drive with worn bushings?
For a while, yes. Meanwhile your tires and ball joints wear faster and the handling gets worse. A badly worn bushing is a safety problem.
Why did new bushings tear quickly?
Nine times out of ten the bolts were tightened with the suspension hanging. We only tighten them under load.
Can you replace one bushing instead of all of them?
Yes, if the others are fine. Bushings on the same arm tend to age together, though, so we'll show you how they look and you decide.
Is an alignment needed after replacement?
Yes. The arm sits in a different position afterwards.
● 06 · Contact
Leave a request — we'll call back and book an inspection
Tell us what happened to the car. We'll call back, answer your questions and find a time. We give the exact price after an inspection: photos don't always show the damage.
By sending the request you accept the privacy policy.
Or message us — we reply right there:
- Address
- Airport Highway 212M, Batumi, Georgia
- Phone / WhatsApp / Telegram
- +995 599 66 66 75 · WhatsApp · Telegram
- Directions
- Google Maps ↗Yandex ↗Waze ↗
