Control Arm Replacement in Batumi
Control arm replacement at PRO SERVICE (Batumi, Airport Highway 212M): front or rear, upper or lower, we replace control arms that got bent in an impact or whose joints are worn out. Labor from 60 GEL per arm, takes 1-2 hours. A wheel alignment follows every replacement.
When an arm needs replacing
- It got bent hitting a pothole or curb. The steering wheel is off-center, the car pulls and you can see the wheel leaning.
- Cracks or corrosion, which we see on imported cars and here by the sea, especially on stamped steel arms.
- The bushings and ball joint are worn on a design where they can't be serviced. On lots of modern cars the arm only comes as a complete assembly.
- Knocking, and the wheel shimmying when you brake or accelerate.
Complete arm or separate parts
You can replace the whole arm. It's quicker and every joint is new, which makes sense when the ball joint is pressed in or the arm is bent. Or, if the arm itself is fine and the parts are sold separately, we can replace just the bushings or the ball joint. Which is the better deal for your car we'll tell you after the inspection, because it comes down to the design and what the parts cost.
How we do it
- Inspection of the arm's shape, the joints and the subframe mounting points.
- Off comes the wheel, and we disconnect the ball joint, the sway bar link and any sensors mounted on the arm.
- Then the arm comes out. Seized arm bolts are common, and we heat them when we have to.
- Fitting the new arm. The bushing bolts are tightened with the car sitting on its wheels. Tighten them with the suspension hanging and the rubber gets twisted and tears quickly.
- Wheel alignment, since the angles always shift after an arm is replaced.
If several parts are bent
A hard hit often damages more than the arm: the tie rod, the rim and sometimes the subframe. If the alignment can't be brought back into spec, you'll need a body geometry check.
Price
| Work | Price, GEL |
|---|---|
| Control arm replacement (each) | from 60 |
| Wheel alignment | from 50 |
| Suspension inspection | from 30 |
FAQ
How much does control arm replacement cost?
Labor from 60 GEL per arm, plus the part. Multi-link rear suspension usually costs more.
Can a bent arm be straightened?
We don't recommend it. Straightened metal is weaker, and the arm is a safety part.
Should arms be replaced in pairs?
Not necessarily. If the arm on the other side is fine, only the damaged one gets replaced.
Aluminum control arm: what is different?
They're lighter, but an aluminum arm tends to crack in an impact instead of bending, and in sea air its mounting bolts can suffer galvanic corrosion. A crack in aluminum isn't always easy to see, so we check closely, especially after a hard curb strike.
Is an alignment required after replacement?
Yes. Skip it and the car pulls and goes through tires fast.
● 06 · Contact
Leave a request — we'll call back and book an inspection
Tell us what happened to the car. We'll call back, answer your questions and find a time. We give the exact price after an inspection: photos don't always show the damage.
By sending the request you accept the privacy policy.
Or message us — we reply right there:
- Address
- Airport Highway 212M, Batumi, Georgia
- Phone / WhatsApp / Telegram
- +995 599 66 66 75 · WhatsApp · Telegram
- Directions
- Google Maps ↗Yandex ↗Waze ↗
