Subaru Forester Timing Belt Replacement in Batumi
Subaru Forester timing belt replacement is only for the boxer EJ20, EJ25 and turbo EJ255: we fit the belt together with the idlers, hydraulic tensioner and water pump. Foresters with FB and FA engines run a chain. PRO SERVICE, Batumi, Airport Highway 212M. Labor from 90 GEL, it takes 4-8 hours, the kit is billed separately.
Forester belt or chain: year and engine code
The line runs through the SH generation. Early Foresters were all EJ with a belt, then the non-turbo versions moved to the FB with a chain.
| Generation | Non-turbo engines | Turbo | Cam drive |
|---|---|---|---|
| SF, 1997-2002 | EJ20, EJ25 | EJ20 turbo | belt |
| SG, 2002-2008 | EJ20, EJ25 | EJ20 turbo, EJ255 (XT) | belt |
| SH up to 2010 | EJ20, EJ25 | EJ20 turbo, EJ255 (XT) | belt |
| SH from about the 2011 model year | FB20, FB25 | EJ20 turbo, EJ255 (XT) | chain on non-turbo, belt on turbo |
| SJ, 2012-2018 | FB20, FB25 | FA20 DIT | chain |
| SK, 2018 on | FB25, FB20 e-Boxer | none | chain |
The switch to the FB didn't happen at the same time for the US, Japan and Europe. So on a 2010 or 2011 SH we don't go by the build year, we read the engine code off the block and match it to the VIN. There's also a quick visual check: an EJ has plastic belt covers on the front, an FB has a big aluminum chain cover. Other weak spots of the SH, SJ and SK are covered on the Subaru Forester repair page.
When to change it on an EJ
Subaru's book interval differs by market and year, and for a car with no history it doesn't settle anything. Most SG and SH Foresters here came through US auctions, and nobody can tell you when the belt was last done. No receipt, we change it straight away.
Rubber ages with time as well as miles. Adjara adds its own load: Foresters carry people up to Khulo and Shuakhevi, climb the Goderdzi switchbacks, sit in summer traffic on Rustaveli. The engine runs hot for long stretches, and any oil weeping from a seal near the belt cooks onto the teeth fast in that heat.
The warning signs on an EJ come late. A whine or a rustle from the front at idle, that's an idler bearing. Oil on the lower cover. If you pull the upper left cover and see cracks at the base of the teeth, it was due yesterday. On the EJ20 and EJ25 a snapped belt can end with valves meeting pistons, and we don't suggest testing your luck.
The EJ kit
On an EJ the water pump is turned by the timing belt, so it goes on the same order. The rest:
- belt with printed timing marks;
- hydraulic auto-tensioner;
- tensioner pulley and idlers, smooth and toothed;
- water pump with gasket, coolant to Subaru spec;
- front crank seal and cam seals if they're weeping;
- the oil pump seal when needed, the pump sits up front behind the belt.
The turbo EJ255 in the XT takes the same kit. Access is tighter because of the top-mount intercooler.
How we do it on a boxer
- Drain the coolant. Take off the radiator fans, and on some cars the radiator itself, to get room in front of the engine.
- Remove the accessory belts, the crank pulley and the three timing covers.
- Set the crank sprocket mark at the top and line up the cam sprocket marks. We mark the old belt so we know how it sat.
- On the twin-cam EJ20 and EJ255 the cam sprockets want to snap round off the valve springs once the belt is off. We hold them with a tool, or the marks are lost.
- Replace the pump, idlers and seals. The new belt goes on with its printed marks lined up with the sprocket marks.
- Squeeze the auto-tensioner slowly in a vise and pin it. Fit it, pull the pin, and the belt tensions itself.
- Turn the crank two full turns by hand and check the marks. Reassemble, refill the coolant and bleed the air. Warm it up and look for leaks.
What we see with the belt off
- Head gaskets on the EJ25. Oil or coolant traces along the lower head joint are visible from under the lift. If there's any, we tell you then, see head gasket replacement.
- Valve cover gaskets, they sit on the sides of a boxer and leak onto the exhaust.
- Thermostat and the plastic radiator tanks.
- Accessory belts and idlers, the AC compressor clutch.
FB and FA: chain
The FB20, FB25 and the turbo FA20 have no mileage-based change. The triggers are a rattle on cold start and cam timing codes. With two cylinder banks, a boxer can set P0018 and P0019 for bank 2 on top of P0016 and P0017. We start with engine diagnostics, and the job itself is on the timing chain replacement page.
Price
| Job | Price, GEL |
|---|---|
| Timing belt EJ20, EJ25, EJ255 (labor) | from 90 |
| Water pump with the belt | from 60 |
| Timing chain FB20, FB25 | from 180 |
| Engine diagnostics | from 30 |
FAQ
I have a 2011 Forester SH. Belt or chain?
Most likely a chain, if it's a non-turbo FB25 or FB20. If it's an XT, it's a turbo EJ and a belt. We check the engine code by VIN in a couple of minutes.
How much is a timing belt on an EJ25?
Labor from 90 GEL. The kit with the pump depends on your pick: genuine Subaru or aftermarket.
The water pump isn't leaking. Should I change it?
Yes. It sits behind the belt, and taking it all apart again a year later costs more than the pump.
The belt snapped on the highway on my EJ. Is the engine OK?
Don't try to start it again. Bring it in on a tow truck. We check compression or scope the valves first, and only then fit a new belt.
Is the belt the same on an SG and an SH?
No. The belt and idlers depend on the engine: the single-cam EJ253 and the twin-cam EJ20 and EJ255 take different kits. We match it by VIN.
● 06 · Contact
Leave a request — we'll call back and book an inspection
Tell us what happened to the car. We'll call back, answer your questions and find a time. We give the exact price after an inspection: photos don't always show the damage.
By sending the request you accept the privacy policy.
Or message us — we reply right there:
- Address
- Airport Highway 212M, Batumi, Georgia
- Phone / WhatsApp / Telegram
- +995 599 66 66 75 · WhatsApp · Telegram
- Directions
- Google Maps ↗Yandex ↗Waze ↗
