Lexus RX Timing Belt Replacement

Lexus RX Timing Belt Replacement in Batumi

Lexus RX timing belt replacement in Batumi only applies to the RX300, RX330 and RX400h: we do the belt in one go with the water pump, the hydraulic tensioner and both pulleys. The RX350 and RX450h run a chain instead. PRO SERVICE, Airport Highway 212M. Belt labor starts at 90 GEL, the car is with us for 4-8 hours, parts are a separate line.

Which Lexus RX has a timing belt and which has a chain

The badge won't tell you. The engine code will.

Model and yearsEngineCam drive
RX300, 1998-2003 (XU10)1MZ-FE, 3.0 V6belt
RX300, 2003-2006 (XU30)1MZ-FE, 3.0 V6belt
RX330, 2003-20063MZ-FE, 3.3 V6belt
RX400h, 2005-20093MZ-FE, 3.3 V6 + electric motorsbelt
RX350, 2007 model year on (XU30)2GR-FE, 3.5 V6chain
RX350 and RX450h, 2009-2015 (AL10)2GR-FE, 2GR-FXEchain
RX350 and RX450h, 2015-2022 (AL20)2GR-FKS, 2GR-FXSchain
RX200t and RX300, 2015-20228AR-FTS, 2.0 turbochain

The rare RX270 with the 2.7 1AR-FE is a chain engine too. For cars built around the 2006-2007 changeover we don't guess from the table, we check the engine code on the block and run the VIN. You can also tell by eye: the belt V6 has a plastic belt cover on the right fender side, the 2GR has an aluminum chain cover there. Everything else that goes wrong on these SUVs, by generation, is on our Lexus RX repair page.

Why the belt on a 1MZ or 3MZ can't wait

Toyota's US schedule calls for a new belt at 90,000 miles, roughly 145,000 km. Most RX300s and RX330s in Georgia came over from US auctions, they are 18 to 25 years old, and nobody hands over a receipt for the last belt. We take the odometer with a grain of salt too. So the rule is short: no record in the book or on an invoice, we replace it on the first visit.

Rubber ages even when the car sits. Plenty of these RXs spent months parked at the Poti lots, then a year of short hot runs around Batumi.

A belt rarely gives a warning. Cracks at the root of the teeth only show with the cover off. Sometimes the idler pulley speaks up first: a whir or a whine from the right side at idle. A snapped belt on these V6s means a tow truck, and on some versions the valves hit the pistons. Then the bill is a cylinder head repair instead of a belt kit, and this engine has two heads.

What goes into the RX kit

On the 1MZ-FE and 3MZ-FE the water pump is driven by the timing belt and sits right behind it. If it starts leaking a year later, the mount, the crank pulley and the covers come off again and you pay that labor twice.

  • Toothed timing belt.
  • Hydraulic tensioner. Oil on the plunger or a tensioner that sags gets replaced.
  • Tensioner pulley and idler pulley.
  • Water pump with gasket, fresh Toyota-spec coolant.
  • Cam and crank seals if they weep. Oil on a belt kills it faster than miles do.
  • Thermostat if you want it, it's right there.

How we do the belt on an RX300 or RX330

The drive sits by the right fender and space is tight. The order:

  1. Drain the coolant, take off the accessory belt and its tensioner.
  2. Support the engine from below and pull the upper right mount. The upper covers don't come out with it in place.
  3. Break loose the crank pulley bolt. It's tight, so we hold the pulley with a proper holder instead of hammering at it with an impact gun.
  4. Bring cylinder one to top dead center and line up the marks on both cam pulleys and the crank gear.
  5. Fit the pump, pulleys and belt. The tensioner gets compressed slowly in a vise and held with a pin, and the pin comes out once the belt is on.
  6. Two full turns of the crank by hand, marks checked again. Only then do we button it up.
  7. Fill and bleed the coolant, warm it up until the fan kicks on, look for leaks.

The RX400h is the same job mechanically, the prep is different. The hybrid starts and stops the engine on its own, so we power the system down per Toyota procedure, and after assembly we warm it up in service mode, where the engine keeps running.

While that side of the engine is open

  • Valve cover gaskets. Oil from the rear head likes to run down onto the exhaust.
  • Mount rubber. The right mount is already out, so any cracks are obvious. The rest we check on the lift, see engine mount replacement.
  • Accessory belt and its pulley. If it's noisy, we do it at the same time, see serpentine belt.
  • Coolant hoses, radiator tanks, power steering seepage.

RX350 and RX450h: you have a chain

On the 2GR the chain is not a mileage item. The reason to open it is noise or cam timing codes on the scanner. A short rattle on a cold start on this engine more often comes from the VVT-i gear on the intake cam, and that's a different job. We start with engine diagnostics and decide from there. The water pump on a 2GR is turned by the accessory belt, so it gets replaced on its own without touching the chain. The chain job itself is on the timing chain replacement page.

Price

JobPrice, GEL
Timing belt RX300, RX330, RX400h (labor)from 90
Water pump together with the beltfrom 60
Timing chain 2GR (RX350, RX450h)from 180
Engine diagnosticsfrom 30

FAQ

How much is a timing belt on an RX330?

Labor starts at 90 GEL. We order the kit with pump and tensioner by VIN, and we agree on OEM or aftermarket before ordering.

Someone told me my RX350 is due for a timing belt. True?

No. The 2GR-FE has a chain. The only belt on it is the accessory belt, which is a small separate job.

Can I do the belt and keep the pump? It isn't leaking.

You can. The pump lives behind the belt though, so if it leaks later the whole teardown happens again. The difference today is the price of the pump.

The belt snapped and the engine cranks over way too easily. Now what?

Don't try to start it again. Tow it to us, we pull the valve covers and check the valves and compression. Only then do we know whether a new belt is enough.

●  Contact

Leave a request — we'll call back and book an inspection

Tell us what happened to the car. We'll call back, answer your questions and find a time. We give the exact price after an inspection: photos don't always show the damage.

By sending the request you accept the privacy policy.

Or message us — we reply right there:

Address
Airport Highway 212M, Batumi, Georgia
Phone / WhatsApp / Telegram
+995 599 66 66 75 · WhatsApp · Telegram
Directions
Google Maps ↗Yandex ↗Waze ↗
PRO SERVICE entrance