Ford Fusion Oil Change in Batumi
A Ford Fusion oil change in Batumi takes 30-40 min on any engine the US-market sedan came with: the 2.5 non-turbo, the EcoBoosts and the hybrids. We drain the old oil, put on a new filter and reset the Oil Life display. Labor starts at 30 GEL at PRO SERVICE, Airport Highway 212M. Our oil or yours: fine, but customer-supplied parts carry no warranty.
Fusion generations, common failures and repairs are on the Ford Fusion page, and the general process is under engine oil change. This page sticks to oil, the filter and what we look at while the car is up.
What oil goes in a Ford Fusion
Ford prints the viscosity right on the oil filler cap. That's where we start: pop the hood, read the cap, check it against the VIN. We don't trust the cap alone. Sometimes it came off a junkyard engine.
| Engine | Where you find it | What we put in |
|---|---|---|
| 2.5 Duratec, non-turbo | most US Fusion S and SE | 5W-20 meeting Ford WSS-M2C945 |
| 1.5 and 1.6 EcoBoost | second generation, 2013-2020 | usually 5W-20, checked against the cap |
| 2.0 EcoBoost | Titanium, some AWD cars | 5W-30 |
| 2.7 EcoBoost V6 | Fusion Sport 2017-2019 | 5W-30 |
| 2.0 Hybrid and Energi | hybrids 2013-2020 | 5W-20 or 0W-20 depending on year |
The 2.5 takes about 5.4 liters with the filter on 2013-2020 cars, about 5 liters on 2010-2012. One 4-liter jug won't cover it, which is the usual surprise when people bring their own oil. For the EcoBoost engines and the hybrid we confirm capacity by VIN before filling.
On the turbo engines we want the Ford spec number printed on the bottle. "Suitable for Ford" with no spec number tells us nothing.
When it's due
The Fusion has Ford's Intelligent Oil Life Monitor. The computer tracks engine speed, temperature and run time and shows what's left as a percentage. The US owner's manual lets the interval stretch to 10,000 miles, about 16,000 km, but never past one year.
The monitor only partly accounts for how cars get driven here. In summer the engine idles for long stretches with the AC running, and a lot of people drive two miles to work, so the oil never gets fully hot. We change it at 30-40% left on the dash, long before zero. A Fusion Hybrid working as a taxi we go by mileage, because the percentage on those runs optimistic.
Signs you've stretched it too far:
- thick black oil on the dipstick a couple thousand km after the last change;
- on an EcoBoost the level on the stick has gone up and the oil smells like gas, which is fuel getting past the rings on short trips;
- the oil pressure light flickers in tight switchbacks, when low oil sloshes away from the pickup.
How we do it on a Fusion
- Car goes on the lift. If it showed up cold, we let it run a few minutes.
- Splash shield comes off if there is one, and the oil drains while it's warm.
- New spin-on filter. For the 2.5 the factory part is a Motorcraft FL-500S, and we match aftermarket ones by part number. The gasket gets a film of fresh oil.
- The drain plug goes back with a new seal. Some Ford plugs have a rubber gasket built onto the plug, and then we just replace the plug.
- We fill slightly under spec, start it, shut it off after a minute and top up to the mark on the stick.
- Step 5 doesn't work the same on the hybrid. With a charged battery the engine won't fire up in park, so we start it with the service procedure and look for leaks at the filter.
- Oil Life gets reset from the cluster menu. Some years still accept the old trick: key on, gas and brake pedals floored, hold until the message comes up.
What else we look at on a Fusion
- Coolant on the 1.5 and 1.6 EcoBoost. We note the level in the reservoir. If there's white sludge under the filler cap, fresh oil won't fix anything. First we find out where the coolant is going, see Ford engine repair.
- 6F35 transmission. Level is checked by Ford's procedure on a warm transmission, and it takes Mercon LV. If the fluid is original from the auction, we'll tell you, and a transmission fluid change only happens if you say yes.
- Leaks. On the 2.5 we check the valve cover and front crank seal. On EcoBoost cars, the turbo oil lines too.
- Filters. Cars that sat on an auction lot for months often come in with leaves packed into the cabin and engine air filters.
Price
| Work | Price, GEL |
|---|---|
| Fusion oil and filter change | from 30 |
| 6F35 transmission fluid change | from 70 |
| Coolant change | from 40 |
| Cabin air filter | from 20 |
| Engine air filter | from 20 |
Oil and the filter are not part of the labor price. You pay for them by receipt.
FAQ
The cap says 5W-20 but the parts store says 5W-30. Who's right?
The cap. The engine is built for the viscosity Ford specified. Thicker oil gets to the cam phaser and chain slower on a cold start.
How much oil should I buy for a Fusion 2.5?
About 5.4 liters with the filter on 2013-2020 cars, about 5 on 2010-2012. A 5-liter jug plus a 1-liter for top-ups is the easy way.
My Fusion Hybrid runs on electric most of the time. Can I go longer between changes?
No. The gas engine on a hybrid starts and stops constantly and often never warms up fully, and oil ages with time anyway. Once a year at the very least.
Oil Life says 50% but it's been a year. Change it?
Yes. Ford caps the interval at one year no matter what percentage the dash shows.
How much is a Fusion oil change?
Labor from 30 GEL. Oil and the filter are extra, and the total depends on the engine: the 2.5 takes more oil than the 1.5.
● 06 · Contact
Leave a request — we'll call back and book an inspection
Tell us what happened to the car. We'll call back, answer your questions and find a time. We give the exact price after an inspection: photos don't always show the damage.
By sending the request you accept the privacy policy.
Or message us — we reply right there:
- Address
- Airport Highway 212M, Batumi, Georgia
- Phone / WhatsApp / Telegram
- +995 599 66 66 75 · WhatsApp · Telegram
- Directions
- Google Maps ↗Yandex ↗Waze ↗
