Ford Fusion Transmission Fluid Change in Batumi
A Ford Fusion transmission fluid change on the 2013-2020 sedan almost always means the 6F35 six-speed, which takes Motorcraft Mercon LV and a level check on a hot transmission. PRO SERVICE, Batumi, Airport Highway 212M: labor from 70 GEL plus fluid.
We mean the US sedan, the one that comes over from American auctions by the boatload. The small European Fusion built on the Fiesta is a different car with different gearboxes.
Which automatic your Fusion has
| Version | Transmission | Fluid |
|---|---|---|
| 2006-2009, 2.3 | Japanese-sourced 5-speed automatic | Mercon V |
| 2010-2012, 2.5 | 6F35 | Mercon LV |
| 2013-2020, 2.5, 1.5, 1.6 and 2.0 EcoBoost | 6F35, a lighter 6F15 on some 1.5 cars | Mercon LV |
| Sport, 2.7 EcoBoost V6 | a heavier-duty 6F-series unit | Mercon LV |
| Hybrid and Energi | stepless electromechanical transmission | Mercon LV |
The first-gen V6 cars had their own six-speeds, and on those we go by the transmission tag. Mercon V and Mercon LV are not interchangeable. LV is thinner, and a 6F filled with Mercon V shifts lazy and late. We see the opposite mistake too: somebody puts LV in the old five-speed "because it's newer."
Checking the 6F35 fluid level: hot only
On the Fusion's 6F35 the level is checked by Ford's procedure and only on a warm transmission, so it's not something you do at a gas station. We read the fluid temperature on the scanner. Check it cold and the level looks low, and people overfill.
The 6F35 filter sits inside the case. A normal fluid change doesn't touch it, and the pan only comes off when there's a reason.
How long you can go
Ford's US maintenance schedule doesn't plan a change for normal driving, only for severe service: taxi, heat, towing. A Fusion in Batumi almost always falls under severe. Hybrids do a lot of taxi work, gas cars sit in summer traffic, and the 2.0 EcoBoost gets driven hard on the highway to Kobuleti. We suggest a drain and fill about every 50 thousand km. Taxis more often.
Signs a 6F35 wants fresh fluid, or something more:
- a bang or a flare on the 2-3 upshift, mostly when it's hot;
- a rumble-strip shudder at 50-70 km/h, which is the torque converter shuddering on lockup;
- D engages late after a start and the car lurches pulling away;
- on early 6F35s (up to 2012) reverse or third gear disappears. That's the known broken wave plate in the 3-5-R clutch pack, and it needs a repair, not fluid.
How the 6F35 fluid change goes
- Scanner: transmission codes, fluid temperature (TFT), software level.
- Drain through the pan plug. Roughly half comes out, the rest stays in the converter and lines.
- Fill Mercon LV following Ford's procedure.
- Bring it up to temperature, run the shifter through the range, set the level by Ford's procedure at the right temperature on the scanner.
- Clear the adaptive tables. Without that, the computer keeps applying the clutches the way it learned on the old fluid, and the first few days can be harsh.
- A relearn drive: easy acceleration through all six gears and a few stops to zero.
If the 2-3 bang is still there after the change and relearn, we check the solenoids and the valve body. Lockup shudder that didn't go away points to the torque converter.
Leaks, mounts and other checks
- Leaks at the pan and axle seals. Auction Fusions with front damage sometimes have a bent pan.
- Engine mounts: they wear out on the 2.5, and the clunk into R gets blamed on the transmission.
- On cars with the rotary dial instead of a lever, we make sure P engages cleanly.
- The 12-volt battery. Low voltage on a Fusion throws strange transmission and shifter codes.
The model's other common problems are on the Ford Fusion repair page.
Price
| Work | Price, GEL |
|---|---|
| Fusion ATF drain and fill | from 70 |
| Automatic transmission diagnostics | from 59 |
| Valve body and solenoid repair | from 150 |
| Second drain and fill to refresh the fluid | same as a drain and fill |
FAQ
Can I put Mercon V in a 6F35 if I can't find LV?
No. The transmission is built for a low-viscosity fluid. Mercon LV isn't hard to find in Batumi, so there's no reason to top off with something else for a couple of days.
Why does my Fusion jerk for the first few days after a fluid change?
If nobody reset the adaptives, the computer applies the clutches from its old tables. We reset them right away, and the first hundred km or so is the relearn.
Does a Fusion Hybrid need a fluid change too?
Yes. The hybrid transmission holds up well, but the fluid ages, especially in a taxi. Same spec, Mercon LV.
It shifts fine on the factory fluid. Leave it alone?
No, but go easy. First we drain a little and check the color and smell. If it isn't burnt, we do a drain and fill, then another one a couple thousand km later.
How much is a transmission fluid change on a Fusion?
Labor from 70 GEL. Fluid is charged by how much came out.
● 06 · Contact
Leave a request — we'll call back and book an inspection
Tell us what happened to the car. We'll call back, answer your questions and find a time. We give the exact price after an inspection: photos don't always show the damage.
By sending the request you accept the privacy policy.
Or message us — we reply right there:
- Address
- Airport Highway 212M, Batumi, Georgia
- Phone / WhatsApp / Telegram
- +995 599 66 66 75 · WhatsApp · Telegram
- Directions
- Google Maps ↗Yandex ↗Waze ↗
