Car Body Welding in Batumi
Car body welding at PRO SERVICE (Batumi, Airport Highway 212M) covers replacing damaged panels, welding in sills and arches, and floor and structural repair after accidents. Prices start at 59 GEL. The job goes by estimate.
Auto body welding: what we weld
Mostly sills, arches, floors and frame rails. We also replace whole panels like rear quarters, the rear panel or the roof, and after an accident we weld structural parts along the factory seam lines.
Why technique matters with thin metal
Body steel is thin. Overheat it and it warps and gets weaker. So we weld in short runs and stick to where the factory put its seams, and every seam gets rust protection and seam sealer afterwards.
How the welding is done
- Inspection. We mark where the rust or damage ends and pull off any trim or parts in the way.
- The bad metal is cut back to sound steel, along factory seams where we can.
- A repair panel goes in, or we make a patch from sheet of the right gauge.
- Tack welds come first. We check the gaps to the panels next door, then lay short runs and let the metal cool between them.
- The seam is ground, primed and sealed, and the inner cavities get anti-corrosion wax.
- If the seam is on show, the panel is prepped and painted.
What affects the price
- How big the damaged area is and how many patches it needs.
- Access. Getting to the floor under the seats, the spare wheel well or a chassis rail under the engine means stripping things out.
- What's next to the weld. Fuel and brake lines, wiring and plastic either come out or get shielded.
- Whether there's a ready-made repair panel or we fabricate a patch here.
- Painting and cavity treatment at the end.
BeforeAfter
FAQ
How much does body welding cost?
From 59 GEL for small repairs. Panel and structural replacement is priced by estimate.
Will the weld rust?
Not if the seam is treated with rust protection and sealed.
Can you weld a hole in the floor?
Yes. We cut out the rotten section and weld new metal in its place.
Why is a patch over the hole a bad idea?
Because the rusty metal is still there underneath, and moisture gets trapped between the two sheets. The rot keeps going where you can't see it. Cut it out and butt-weld new metal in instead.
Is it safe to weld near the fuel tank and wiring?
Yes, with precautions. The tank and lines are removed or shielded first, and we disconnect the battery to protect the electronics.
How can I tell the welding was done properly?
Look for a continuous seam with no burn-through or pinholes. The panel beside it shouldn't be rippled, and the gaps to neighboring parts should be even. On the inside the seam is covered in sealer and anti-corrosion coating, with no bare metal.
Why not use stick welding?
Stick (arc) welding puts too much heat into thin body steel, so the sheet burns through and warps. Body work needs MIG under shielding gas or resistance spot welding.
● 06 · Contact
Leave a request — we'll call back and book an inspection
Tell us what happened to the car. We'll call back, answer your questions and find a time. We give the exact price after an inspection: photos don't always show the damage.
By sending the request you accept the privacy policy.
Or message us — we reply right there:
- Address
- Airport Highway 212M, Batumi, Georgia
- Phone / WhatsApp / Telegram
- +995 599 66 66 75 · WhatsApp · Telegram
- Directions
- Google Maps ↗Yandex ↗Waze ↗
