Wheel Arch Repair in Batumi

Wheel Arch Repair in Batumi

Wheel arch repair at PRO SERVICE (Batumi, Airport Highway 212M): we cut out the rotten metal, weld in a repair arch, treat the weld and the cavity with rust protection, and paint. It starts at 175 GEL per arch. It takes 2-3 days.

Signs the arches need repair

Paint bubbling along the edge of the arch and rusty streaks running down from it. Holes you can see once the fender liner is out of the way. Or simply a dent from a run-in with a curb.

How we repair

  1. Pull the fender liner and see how far the rust goes.
  2. Cut out the rotten metal until we're into clean steel.
  3. Weld in a repair arch or a patch, and treat the weld.
  4. Filler, primer, paint, then rust protection.

Where the rust starts

A rear arch is two panels, an outer and an inner, welded together along the lip. Dirt and sand pack into that seam and hold water, so the rot usually starts on the inside. From outside you see a few bubbles. Behind the liner the metal is already gone.

Why we don't just fill over rust

Cover a rotten arch with filler and paint and the rust carries on under it. The bubbles come back, and bigger. That's why we cut out everything that's affected back to sound metal, even if only a small spot shows on the outside.

What affects the price

Front or rear makes a big difference. The rear arch is part of the body shell, so it's the harder job. Then it's how far the corrosion has spread: just the lip, the whole arch, or the inner arch and the sill along with it. A patch is less work than a complete repair arch.

Paint matters too. Sometimes we only paint the repair area; sometimes it's the whole quarter panel or fender, so there's no blend line to spot. And if the bumper, tail light or fuel door is in the way, it has to come off.

How to check the result

  • Ask to see the metal after we've cut it out and before we weld. The edges should be clean, no rust.
  • Once it's painted, the line of the arch should be smooth and match the other side.
  • Inside the arch, the weld should be covered with seam sealer and rust protection.
  • The fender liner goes back in with all of its fasteners.
Car before repair Car after repair BeforeAfter

FAQ

How much does arch repair cost?

From 175 GEL per arch, painting included. Rear arches take more work than front ones because they're part of the body and don't come off.

Why do arches rust?

The wheel keeps throwing sand and water at them. The paint wears through and the metal never dries out.

Do I need fender liners?

If your car doesn't have them, yes. They protect the arch from getting sandblasted.

How long will it take?

2-3 days.

Can you put a patch in instead of a repair arch?

When the hole is small and the metal around it is solid, yes, we weld in a patch. When the rot runs the whole length of the lip, a complete repair arch is the safer way to go.

Will the repair be visible?

Not if the weld is filled and painted properly. To keep the shade right we match the color by paint code, and paint the whole panel if we need to.

If the rust is just starting, does it have to be welded?

No. If the paint has bubbled but the metal underneath hasn't rusted through, we sand down to metal, treat the rust, prime and paint. Then the arch gets sealed from inside with rust protection.

●  06 · Contact

Leave a request — we'll call back and book an inspection

Tell us what happened to the car. We'll call back, answer your questions and find a time. We give the exact price after an inspection: photos don't always show the damage.

By sending the request you accept the privacy policy.

Or message us — we reply right there:

Address
Airport Highway 212M, Batumi, Georgia
Phone / WhatsApp / Telegram
+995 599 66 66 75 · WhatsApp · Telegram
Directions
Google Maps ↗Yandex ↗Waze ↗
PRO SERVICE entrance