Frame Bench Body Straightening

Frame Bench Body Straightening in Batumi

Frame bench straightening at PRO SERVICE (Batumi, Airport Highway 212M) brings the body geometry back after a hard hit. We clamp the car on the frame bench, measure its control points, and pull the frame rails, pillars and openings back to the manufacturer's dimensions. It starts at 109 GEL, painting not included. It takes 1-3 days.

When you need frame bench repair

Usually the car tells you itself. Doors, hood or trunk take effort to close, or the gaps around them aren't even. After the impact the car pulls to one side and the steering wheel sits crooked. Maybe a frame rail, pillar, floor or front/rear panel took the hit, or the tires have started wearing unevenly since the accident.

A hammer only fixes the outer panel. If the structure underneath has shifted, the geometry stays wrong until the car goes on a bench.

How the bench work goes

  1. Measuring. We check the body points against the dimensions in the manufacturer's technical documentation.
  2. Clamping. The car is fixed rigidly to the bench frame at the factory points.
  3. Pulling. Chains and pulling towers draw the deformation back the way it came, and we keep measuring as we go.
  4. A final measurement once we're done, plus a photo of the result.
  5. After that comes welding, any part replacement, painting and a wheel alignment.

Price and timing

ScopePrice, GELTime
Pulling one zone (frame rail, opening)from 1091 day
Full geometry restorationfrom 800on inspection

What affects the price

  • How many zones need pulling. One side is one thing, the front end or a diagonal twist is another.
  • How far the impact went in, whether to the chassis rail, inner fender apron, pillar or floor.
  • What has to come off to get at it: bumper, radiators, subframe, suspension parts.
  • Parts too far gone to pull, which get replaced and welded in.
Car before repair Car after repair BeforeAfter

FAQ

How much does a frame bench cost in Batumi?

From 109 GEL to pull one zone. The total depends on how many points we work on and whether anything needs replacing, and you get an estimate after measuring.

Can geometry be restored without a frame bench?

For outer panels, yes. For the structure (frame rails, pillars, floor), no. Without clamping and measuring, the body springs back or twists somewhere else.

Will the car be like it was before the accident?

If the metal isn't torn or creased, we get the geometry back within the manufacturer's tolerances. If a part can't be saved, we'll tell you before work starts and suggest replacing it.

Do I need a wheel alignment after the frame bench?

Yes, every time. Pulling moves the points the suspension mounts to.

Can I drive the car to you?

Yes, as long as the wheels sit straight, nothing rubs or leaks, and the lights and indicators work. Take it easy and stay off the highway. If a wheel has been shoved back in the arch, or the steering wheel is way off-center when you drive straight, call a tow truck.

Will an inspection show the car was on a frame bench?

The pulling itself leaves few marks, but welds, replaced parts and paintwork will show. We don't hide repairs.

●  06 · Contact

Leave a request — we'll call back and book an inspection

Tell us what happened to the car. We'll call back, answer your questions and find a time. We give the exact price after an inspection: photos don't always show the damage.

By sending the request you accept the privacy policy.

Or message us — we reply right there:

Address
Airport Highway 212M, Batumi, Georgia
Phone / WhatsApp / Telegram
+995 599 66 66 75 · WhatsApp · Telegram
Directions
Google Maps ↗Yandex ↗Waze ↗
PRO SERVICE entrance