Engine Burning Oil: Where It Goes and How Much Is Normal

Engine Burning Oil: Where It Goes and How Much Is Normal

Updated: · PRO SERVICE

If your engine is burning oil, or the level just keeps dropping, the first thing to find out is where it goes: out of the engine as a leak, or into the cylinders where it burns. A leak shows underneath and is usually the easier fix. Oil burns through the rings, the valve stem seals, the crankcase ventilation or the turbo. If you add less than half a liter between changes, the engine is most likely fine.

How much oil use is normal

Many carmakers put a generous limit in the manual, some as much as 0.5-1 liter per 1,000 km. That's the point where the factory agrees the engine is faulty, not what a healthy car should use. Our rule of thumb:

  • under 0.5 liter between changes: nothing to worry about;
  • about a liter every 2,000-3,000 km: time to find the cause;
  • a liter per 1,000 km or more: the engine is heading for repair, and the catalytic converter is already taking damage.

How to measure it properly

"I top up now and then" tells us nothing. Here's how to measure:

  1. Park on level ground with the engine warm, then switch off and wait ten minutes.
  2. Fill exactly to the top mark on the dipstick and write down the mileage.
  3. Drive normally for 1,000-1,500 km.
  4. Check under the same conditions and top up to the mark with a measuring jug. What went in is what the engine used.

Sometimes it goes the other way and the level rises. That's a different problem. Fuel is getting into the oil (short trips, direct injection) or coolant is, and that needs diagnostics right away.

Leaking or burning

Signs of a leak: spots on the pavement in the morning, a wet oil pan and bottom of the transmission, a burning oil smell after a drive when drops land on the exhaust. The usual leaks are the valve cover gasket, the oil pan, the oil filter or oil cooler housing, and the crankshaft seals.

Signs of burning: dry underneath, but the level drops. Oily carbon on the plugs. Blue smoke from the tailpipe at startup or when you accelerate; more on colors in smoke from the exhaust. Small amounts get burned off in the catalytic converter, so you may see no smoke at all.

Oil consumption causes: how oil gets burned

Valve stem seals. The rubber hardens with heat and age. The classic sign: a puff of blue smoke on the first start of the morning that clears quickly. They can be replaced without taking the engine apart.

Piston rings. They stick with carbon when oil changes were stretched and the car spent years on 3-5 km trips. Smoke comes under load and compression drops. If the rings are only stuck, a ring decarbonizing treatment sometimes frees them. If they're worn, it's an engine rebuild. Some engines are known for this: Toyota 2AZ-FE, VW and Audi 1.8/2.0 TFSI from the second-generation EA888, Honda V6 engines with cylinder deactivation.

Crankcase ventilation. A stuck PCV valve or a torn diaphragm in the oil separator pulls oil mist into the intake. The mechanical parts are fine and the oil still disappears. It's a cheap repair, so we check it first. On many German engines the diaphragm sits right in the valve cover.

Turbo. The shaft seals wear and oil gets into the intake or exhaust side. You'll find oil in the intercooler pipes and see smoke under load. Before replacing a turbo we check its oil drain and the crankcase ventilation: with high crankcase pressure, oil gets pushed past perfectly good seals. More on the turbo repair page.

Overfill. Oil above the max mark gets pushed out through the ventilation. The cheapest cause of all.

Why not live with it for years

The level can drop below minimum between checks. Then oil pressure falls, and the bearings, the timing chain and the turbo all suffer. Burned oil leaves carbon on the valves and plugs and poisons the catalytic converter. On a diesel, it clogs the particulate filter.

How we find the cause

  • Look at the engine from below on the lift. If it's covered in old leaks, we clean it and watch where fresh oil shows up.
  • Check crankcase vacuum at idle and test the PCV valve.
  • Pull the plugs: an oily one points to the cylinder.
  • Test compression and, if we suspect the rings, look at the cylinder walls with a borescope.
  • On a turbo engine, take off the pipe after the turbo and see how much oil is in it.

Book engine diagnostics at PRO SERVICE, Airport Highway 212M: from 30 GEL. If the repair turns out expensive, we'll help you weigh the options; see rebuild or used engine.

FAQ

Can I just switch to thicker oil?

Oil use drops a little, the cause stays. On an engine built for 0W-20, thick oil gets in the way of the variable valve timing. How to pick viscosity is in how to choose engine oil.

Do oil stop-burn additives work?

Rarely, and not for long. They soften the rubber in the valve stem seals. No additive will bring worn rings back.

I'm losing oil but there's no smoke. Where is it going?

Either a leak you can't see from above, or the engine burns a little at a time and the catalytic converter cleans it up. We start with a look from below.

My engine uses oil after a rebuild. Is that normal?

For the first 1,000-2,000 km, while the rings seat, oil use can be higher. After that it should drop. If it doesn't, the engine needs a look.

●  06 · Contact

Leave a request — we'll call back and book an inspection

Tell us what happened to the car. We'll call back, answer your questions and find a time. We give the exact price after an inspection: photos don't always show the damage.

By sending the request you accept the privacy policy.

Or message us — we reply right there:

Address
Airport Highway 212M, Batumi, Georgia
Phone / WhatsApp / Telegram
+995 599 66 66 75 · WhatsApp · Telegram
Directions
Google Maps ↗Yandex ↗Waze ↗
PRO SERVICE entrance