Clutch Replacement: Cost and What We Replace in Batumi
Clutch replacement at PRO SERVICE (Batumi, Airport Highway 212M) covers the disc, pressure plate and release bearing, plus the flywheel and hydraulic cylinders when they need it. Clutch replacement cost starts from 150 GEL, time 1 working day. Before we pull the gearbox, we make sure the problem isn't in the hydraulics.
Signs of a worn clutch
- Slipping. On a hill or when overtaking, the revs go up but the speed doesn't, and you may smell burning.
- The clutch bites at the very top of the pedal travel. That usually means the disc is almost gone.
- Judder when pulling away: oil on the disc, or a warped flywheel or pressure plate.
- Noise with the pedal pressed points to the release bearing. Noise with the pedal released is more often the gearbox input shaft bearing.
- Gears grind going in and the clutch drags, because the pressure plate or hydraulics don't fully disengage.
- Pedal sinks or stays on the floor (master or slave cylinder, fluid leak).
What we replace and why as a kit
The disc, pressure plate and release bearing usually go in together. Most of the labor is getting the gearbox out, and there's no sense paying for that twice. While it's apart we also check the dual-mass flywheel, which many diesels and powerful petrol engines have. A knock when you switch the engine off, or too much play, means it's worn. We look at the crankshaft and input shaft seals as well, since oil on a new disc will make it slip again unless the leak is fixed. And we check the cylinders, hose or cable.
Pedal feels wrong but the clutch doesn't slip? Sometimes a new master or external slave cylinder is enough, with no gearbox removal. A concentric slave cylinder sits inside the bell housing, so it can only be replaced with the gearbox out, and it's usually done along with the clutch kit.
How the job goes
- First the checks: a slip test in a high gear, the bite point, and hydraulic leaks.
- Gearbox removal. On all-wheel drive the transfer case and propshaft come off too, so it takes longer and costs more.
- We inspect the flywheel, seals, fork and guide tube, and show you the worn parts.
- New kit goes in, hydraulics get bled, then a road test.
Adjara's mountain roads and Batumi city traffic are hard on a clutch, and hill starts wear the disc fastest. The dry clutch in a DSG is a different job with its own procedure and relearn; see DSG repair.
Prices
| Service | Price, GEL |
|---|---|
| Clutch replacement (kit) | from 150 |
| Master or slave cylinder replacement | from 80 |
| Flywheel replacement | from 200 |
FAQ
How much does a clutch replacement cost?
Labor starts from 150 GEL. The final price depends on the drivetrain, the engine and whether the flywheel needs replacing. Your own parts: fine, but customer-supplied parts carry no warranty
How long does a clutch last?
That's down to driving style and conditions. City traffic and mountains wear it faster, highway miles slower. We go by symptoms rather than mileage.
Can you replace just the disc?
Technically yes. But if the pressure plate or release bearing is worn, the gearbox will be coming out again soon, so we decide after inspection.
How long does it take?
1 working day, longer for all-wheel drive or a dual-mass flywheel.
● 06 · Contact
Leave a request — we'll call back and book an inspection
Tell us what happened to the car. We'll call back, answer your questions and find a time. We give the exact price after an inspection: photos don't always show the damage.
By sending the request you accept the privacy policy.
Or message us — we reply right there:
- Address
- Airport Highway 212M, Batumi, Georgia
- Phone / WhatsApp / Telegram
- +995 599 66 66 75 · WhatsApp · Telegram
- Directions
- Google Maps ↗Yandex ↗Waze ↗
