Driveshaft Repair

Driveshaft Repair in Batumi

Driveshaft repair at PRO SERVICE (Batumi, Airport Highway 212M): we trace the vibration or clunk and replace whatever is worn, whether that's the U-joints, the center support bearing or the flex disc. U-joint replacement from 80 GEL. Center bearing from 139 GEL. Time is 3-5 hours.

Is it the driveshaft?

  • Vibration that builds with speed and comes through the floor and seats more than the steering wheel. If it's the wheel that shakes, look at the wheels first.
  • A metallic click or clunk when you pull away, or when you go sharply from throttle to brake. That's play in a U-joint or the splines.
  • A hum or rumble from under the middle of the car usually means the center support bearing.
  • Vibration on acceleration that goes away when you lift off points to a worn center support or worn driveshaft joints (some models use CV joints instead of U-joints).
  • A squeak at low speed: a dry U-joint.

Rear-wheel and all-wheel-drive cars have a driveshaft. On front-wheel-drive cars the same kind of symptoms usually come from the CV joints, and that's a different job.

What we check

  1. Up on the lift we look for play in the U-joints and splines, check the center bearing and its rubber, and look for cracks in the flex disc (guibo).
  2. Alignment marks and balance weights. When a shaft has been off before and went back out of phase, vibration is almost guaranteed.
  3. Engine and gearbox mounts. A sagging mount changes the driveshaft angles and causes very similar vibration.
  4. The seals where the shaft enters the gearbox, transfer case and differential.

Fix the parts or replace the shaft

On most cars the U-joints, center bearing and flex disc are replaced one by one, and the shaft itself stays. A bent shaft is another story. Say you hit a rock on a dirt road, or the vibration is still there after new parts: then it needs straightening and balancing, or a complete replacement. We decide after the inspection.

Before the shaft comes off we always mark it so it goes back in the same position, and the fasteners get torqued to spec.

Prices

ServicePrice, GEL
U-joint replacementfrom 80
Center support bearing replacementfrom 139
Flex disc replacementfrom 80

FAQ

Can I drive with driveshaft vibration?

Briefly, and gently. A U-joint that lets go can drop the shaft while you're driving, which damages the underbody and gearbox and is a real crash risk.

Why did vibration start after a clutch or gearbox job?

Most often the shaft went back out of phase or the bolts weren't torqued. It's quick to check.

Does the whole driveshaft need replacing?

Usually not. What wears out are the U-joints, center bearing and flex disc. The whole shaft only goes if it's bent or the splines are worn.

How long does it take?

3-5 hours, longer if parts need ordering.

●  06 · Contact

Leave a request — we'll call back and book an inspection

Tell us what happened to the car. We'll call back, answer your questions and find a time. We give the exact price after an inspection: photos don't always show the damage.

By sending the request you accept the privacy policy.

Or message us — we reply right there:

Address
Airport Highway 212M, Batumi, Georgia
Phone / WhatsApp / Telegram
+995 599 66 66 75 · WhatsApp · Telegram
Directions
Google Maps ↗Yandex ↗Waze ↗
PRO SERVICE entrance