Honda Suspension Repair in Batumi
Honda suspension repair at PRO SERVICE in Batumi, Airport Highway 212M. We put the car on the lift, find what's knocking or pulling, and replace shocks, control arms, bushings and sway bar links as needed. Every job ends with a wheel alignment. The inspection starts at 30 GEL and takes 30-40 min, and shock absorber replacement starts at 30 GEL.
Clunking noise over bumps and other Honda complaints
What follows is what we see on the Civic, CR-V and Accord, though a lot of it goes for the Fit/Jazz, HR-V, Pilot and Odyssey as well. Many Hondas here were imported used, so it's common to find several parts worn out at the same time.
If you hear a dull clunk over small bumps, the first suspect is a sway bar link. It's a cheap part, and people often take its knock for a bad shock.
- The rear bushing of the front lower control arm is a well-known weak spot on the Civic, CR-V and Accord. The wheel wobbles when you brake, the car feels floaty at speed, and the rubber is visibly cracked.
- Rear shocks that are done let the car keep bouncing after a bump. It bottoms out with passengers or a full trunk, and you may see oil on the rod.
- Rear tires wearing on the inner edge. Several Civic and CR-V generations use a multi-link rear end, and tired springs or worn bushings knock the camber out. We check the angles and the arms instead of just selling you new tires.
Rear groan on a CR-V? Check the differential first
On an AWD CR-V, grinding or shudder from the back in slow tight turns very often comes from the rear differential fluid. The suspension may be fine. We rule that out before replacing any suspension parts, and sometimes a differential fluid change is all the car needs.
How we do it
- A test drive with you in the car, so you can show us where it knocks, on which bumps, and whether it's turning or braking.
- On the lift we check for play in the arms, ball joints and tie rods, look at the bushings, and check the shocks for leaks.
- Itemized estimate. We'll tell you what has to be done now and what can wait.
- Replacement. Shocks go in pairs per axle. Bushings are either pressed into the arm or we fit a complete arm, depending on what parts are available and what shape the arm is in.
- A wheel alignment after any arm, tie rod or strut replacement.
What affects the price
The model and suspension design matter most. Depending on the year, a Honda has MacPherson struts or a double wishbone up front, and usually a lot of arms at the back. On a 4WD CR-V or HR-V the rear parts are harder to get to. Then there's OEM versus aftermarket and what's in stock in Batumi. On high-mileage cars, bolts seized by our humid climate add time too.
Price
| Job | Price, GEL |
|---|---|
| Suspension inspection | from 30 |
| Shock absorber replacement (1 pc) | from 30 |
| Control arm bushing replacement | from 60 |
| Wheel alignment | from 50 |
FAQ
How much does shock absorber replacement cost on a Honda Civic?
Labor starts at 30 GEL per shock. The parts depend on the Civic generation and whether you go OEM or aftermarket.
What does suspension repair cost on a 2008 CR-V?
That depends on what's worn, whether links, bushings or shocks. After the inspection you get an itemized estimate.
Do shocks have to be replaced in pairs?
Yes, in pairs per axle. If you don't, the car handles differently on the left and the right.
Why are my rear tires wearing on the inside?
On many Hondas that's rear camber. We check the angles and the arm bushings and replace the arms if they need it.
● 06 · Contact
Leave a request — we'll call back and book an inspection
Tell us what happened to the car. We'll call back, answer your questions and find a time. We give the exact price after an inspection: photos don't always show the damage.
By sending the request you accept the privacy policy.
Or message us — we reply right there:
- Address
- Airport Highway 212M, Batumi, Georgia
- Phone / WhatsApp / Telegram
- +995 599 66 66 75 · WhatsApp · Telegram
- Directions
- Google Maps ↗Yandex ↗Waze ↗
