Valve Adjustment in Batumi

Valve Adjustment in Batumi

Valve adjustment in Batumi at PRO SERVICE (Airport Highway 212M). With the engine cold, we measure every valve clearance with feeler gauges, compare it to the manufacturer's spec and set it with adjusting screws or new shims. From 100 GEL, takes 2-4 hours. Before we start, we check whether your engine needs adjusting at all.

Which engines need it

Only engines without hydraulic lifters need it. On those, the gap between the cam lobe and the valve is set mechanically and drifts over time. You'll find this setup on plenty of Japanese and Korean cars and on a fair number of diesels. Got hydraulic lifters? Then there's nothing to adjust, and a tick means we look at the lifters and the oil pressure instead.

How often to check is written in the manufacturer's schedule. If you've just bought a used car with an unknown history, it's smart to have the clearances checked straight away.

Signs of wrong clearances

  • Too much clearance gives you a sharp, quick ticking from the top of the engine, louder when it's cold. The valve opens less, so you lose some power.
  • Too little clearance is the one to worry about. It's silent, but the valve never fully closes. You get a rough idle, hard cold starts and low compression, and eventually the exhaust valve overheats and burns. At that point it's a cylinder head repair.
  • Smoke or popping from the exhaust, and higher fuel use.

How we do it

  1. The car has to cool down first, because clearances are measured cold.
  2. Off come the valve cover, the coils and whatever else is in the way.
  3. We turn the crank to the marks, measure each valve with a feeler gauge and write every number down.
  4. With screw adjusters, it's loosen the locknut and set the gap. With shims or buckets we work out the thickness needed, pull the camshafts if we have to and fit new shims.
  5. Measure again, fit a new valve cover gasket and button it up.
  6. Start it and listen for noise, check for misfires and fault codes.

You get the measurement sheet, so you can see which valves were out of spec. If the valve cover gasket was leaking, we swap it during the same visit since the cover is off anyway.

What affects the cost

Screw adjusters are quicker; shims often mean taking the camshafts out. The number of valves and heads matters too (an inline four is a different job from a V engine). And it depends on how many shims need replacing and whether they're in stock.

Price

WorkPrice, GEL
Valve adjustment (labor)from 100
Engine diagnosticsfrom 30
Cylinder head repair for a burnt valvefrom 300

FAQ

How do I know if my engine has hydraulic lifters?

It's down to the model and engine code. Give us the make and engine size when you book and we'll look it up beforehand.

My valves are ticking. Can I keep driving?

For a short while, yes. Ticking from a wide gap is annoying, not urgent. The silent tight gap is worse, because that's how valves burn. Don't keep putting the check off.

How much does a valve adjustment cost?

Labor starts at 100 GEL. Shims and the valve cover gasket are extra.

How long will it take?

2-4 hours on screw-type engines. Shim engines take longer if the shims have to be ordered.

●  06 · Contact

Leave a request — we'll call back and book an inspection

Tell us what happened to the car. We'll call back, answer your questions and find a time. We give the exact price after an inspection: photos don't always show the damage.

By sending the request you accept the privacy policy.

Or message us — we reply right there:

Address
Airport Highway 212M, Batumi, Georgia
Phone / WhatsApp / Telegram
+995 599 66 66 75 · WhatsApp · Telegram
Directions
Google Maps ↗Yandex ↗Waze ↗
PRO SERVICE entrance