When to Replace Spark Plugs: Intervals by Plug Type and Warning Signs
Updated: · PRO SERVICE
Nickel spark plugs (often called copper) last about 15,000-30,000 km. Iridium and platinum plugs go 60,000-100,000 km, and longer on some Japanese engines. When to replace the plugs in your engine exactly is in its service schedule. If the car runs on LPG, cut that interval roughly in half.
Find out which plugs you have
Count the interval from the plugs actually sitting in the engine, not the ones the factory put there. You can tell them apart by eye. A nickel plug has a thick center electrode. On an iridium plug it's a thin needle, 0.4-0.7 mm. The part number is stamped on the insulator, and we can look up the type in the NGK or Denso catalog in a minute.
Here's a common one: the schedule calls for 100,000 km iridium plugs, but the last owner put in cheap nickel ones. After 20,000-25,000 km they start misfiring, and the driver thinks the next change is years away. We see it a lot on imported cars with no service records.
Why plugs wear out sooner in real life
- LPG. A gas mixture is harder to light. The coil has to push more voltage, the electrodes burn away faster and the gap grows.
- Turbo with direct injection. Cylinder pressure is high and the plug works harder. Many of these engines have a noticeably shorter plug interval than the non-turbo engines from the same brand.
- Short trips. The plug never gets hot enough to burn itself clean, so carbon builds up. Home, work, shop, 3-4 km each: that's a normal day in Batumi.
- Oil in the plug wells. A leaking valve cover gasket lets oil in, the oil eats the rubber coil boots, and the spark jumps to ground.
Signs of bad spark plugs
The engine shakes at idle or stumbles when you accelerate up a hill. It takes a few tries to start, especially after a damp night. Fuel use creeps up while the car pulls worse. Codes P0300-P0308 show up and the Check Engine light comes on (what to do then is covered in Check Engine light on). On LPG all of this shows up earlier and harder than on gasoline.
If the engine is already clearly misfiring, the plugs may not be the cause. How we track down the bad cylinder is a separate article: engine misfire.
Should the coils go with the plugs?
No. Coils don't have a replacement interval. You replace the one that's failing. When we change plugs, though, we pull every coil and look at the rubber boot. A crack, a white or black tracking line, oil inside: that boot should go right away. It's often sold separately and costs less than a whole coil. On an LPG car a weak coil gives itself away fast. The engine runs smooth on gasoline, then one cylinder starts missing on gas.
How we replace plugs
- We only take plugs out of a cold engine. Threads in an aluminum head strip more easily when it's hot.
- Before removing them, we blow out the wells with compressed air so sand and dirt don't drop into the cylinder.
- We lay the old plugs out in cylinder order. The deposits tell you which cylinder has oil, which runs rich and which is fine. We show you.
- We don't touch the gap on iridium plugs. It's set at the factory, and a feeler gauge can snap the thin electrode.
- New plugs go in with a torque wrench at the catalog spec. Too tight pulls the thread, too loose and the plug overheats.
Interval guide
| Plugs | Typical interval | Keep in mind |
|---|---|---|
| Nickel | 15,000-30,000 km | shorter still on LPG |
| Platinum and iridium | 60,000-100,000 km, longer on some Japanese engines | exact number is in the engine's schedule |
| Any plugs on LPG | about half the gasoline interval | check them at every service |
Where to change plugs in Batumi
At PRO SERVICE, Airport Highway 212M, we do spark plug replacement with a check of every coil boot. We quote the price after a look: on an inline four everything is right there, while on some V6 engines the rear plugs only come out after the intake comes off. If the engine still misfires with new plugs, you need engine diagnostics, from 30 GEL. Plugs are easy to do together with a scheduled service.
FAQ
I bought a car and don't know when the plugs were changed. What now?
Change them. On a four-cylinder it doesn't cost much, and the old plugs show you how each cylinder has been running.
Can I put iridium plugs in an engine that had nickel ones?
Yes, if the size and heat range match the catalog. They'll last longer. Don't expect the extra power the ads promise.
Why does my engine misfire after an engine wash?
Water got into the plug wells or onto the coils. If the problem goes away once things dry out, you're fine. If it stays, a boot is cracked, and the water just showed it sooner.
My plugs still look OK. Can I leave them?
Looks don't tell you much. Electrode wear shows in the gap, not the color. We measure the gap and check the mileage.
● 06 · Contact
Leave a request — we'll call back and book an inspection
Tell us what happened to the car. We'll call back, answer your questions and find a time. We give the exact price after an inspection: photos don't always show the damage.
By sending the request you accept the privacy policy.
Or message us — we reply right there:
- Address
- Airport Highway 212M, Batumi, Georgia
- Phone / WhatsApp / Telegram
- +995 599 66 66 75 · WhatsApp · Telegram
- Directions
- Google Maps ↗Yandex ↗Waze ↗
