Parking Sensor Repair

Parking Sensor Repair in Batumi

Parking sensor repair at PRO SERVICE (Batumi, Airport Highway 212M): we track down the faulty sensor or broken wire, replace the sensor and paint it to body color if needed. Diagnosis and repair from 39 GEL. Time is 1-2 hours without painting.

Common faults

  • It beeps constantly with nothing behind you. Usually that's dirt, ice or water on a sensor, a cracked sensor body, or a sensor that's shifted in the bumper.
  • Completely silent: check the fuse, the control unit, the main harness for a break, or a stored fault.
  • It misses obstacles on one side. One sensor or its connector has died.
  • It quit after bumper repair or paint. Someone didn't reconnect it, a holder broke, or there's too much paint on the sensor face.
  • A warning shows on the dash. With factory systems the module already knows which channel isn't responding.

How we find the bad sensor

If the system is factory-fitted and the scanner supports it, we start by reading the park assist module codes. Then we check each sensor by hand. A working one vibrates and ticks lightly when active; a dead one stays still.

The bumper harness gets tested too. Wiring in there takes a beating from small knocks, pressure washers and salty sea air, and corroded connectors are a frequent cause here in Batumi. We replace only the faulty sensor, not the whole set.

Parking sensors and bumper repair

After a collision the sensors themselves are often fine but their holders in the bumper are broken. During bumper repair we restore the holders or bond in new ones, and the sensors get painted separately in a thin coat, since thick paint deadens the signal. Sending the bumper in for paint? Have the sensors checked at the same time so you don't end up painting twice.

Price

ServicePrice, GEL
Parking sensor diagnosisfrom 39
Sensor replacement (labor)from 39
Painting a sensor to body colorfrom 40

FAQ

Can you replace just one sensor?

Yes. We match it by part number or car model, because the wrong sensor can make the whole system misbehave.

Does a new sensor need painting?

Many come black or in primer. Painting to body color is up to you. We keep the coat thin so the sensor still works.

Why does it beep in the rain?

Water drops on a sensor look like an obstacle to it. If it keeps beeping once everything dries, the sensor is probably letting moisture in.

How long does it take?

1-2 hours without painting. If painting is involved, we'll give you the time at drop-off.

●  06 · Contact

Leave a request — we'll call back and book an inspection

Tell us what happened to the car. We'll call back, answer your questions and find a time. We give the exact price after an inspection: photos don't always show the damage.

By sending the request you accept the privacy policy.

Or message us — we reply right there:

Address
Airport Highway 212M, Batumi, Georgia
Phone / WhatsApp / Telegram
+995 599 66 66 75 · WhatsApp · Telegram
Directions
Google Maps ↗Yandex ↗Waze ↗
PRO SERVICE entrance