Check Engine Light Sensors: Testing, Replacement and Price

Check Engine Light Sensors: Testing, Replacement and Price in Batumi

Check engine light sensor diagnosis at PRO SERVICE (Batumi, Airport Highway 212M): we test the suspect part with live data and a circuit check, and replace only what is actually faulty. Labor price from 65 GEL per sensor. Time is 30-90 min depending on access.

Common sensors and the symptoms they cause

  • Oxygen (O2) sensor. It reads the air-fuel mixture, and when it starts failing you see higher fuel use plus mixture or catalyst codes.
  • MAF / MAP: measures how much air enters the engine. Expect hesitation, a hunting idle and weak pull.
  • Crankshaft position. Without its signal the engine won't start, or it stalls once hot.
  • Camshaft position sensor: hard starting, timing codes, limp mode.
  • Coolant temperature. Hard cold starts, a fan that never kicks in or runs nonstop, a gauge that reads wrong.
  • Oil pressure sensor. The oil light flickers or stays on. We check real oil pressure first, because sometimes the part is fine and the pressure isn't.
  • Knock sensor: loss of power, a fault code, retarded ignition.
  • ABS wheel speed. ABS and ESP lights come on, and on some cars the speedometer quits too.

Why a code alone isn't enough to replace a part

A "sensor X" code means the ECU sees an odd signal on that circuit. Maybe the part is dead. Maybe it's the wiring or the connector. Or there's a real mechanical problem and the sensor is reporting it honestly; an O2 code caused by a vacuum leak or misfires is a classic example. So we compare live data with normal values for your engine, then go over the wiring and connector (corrosion in Batumi's humid climate is a frequent culprit). Where possible we bench-test the sensor. Only then do we replace it, and we confirm after a test drive that the code stays gone.

What affects the price

Part price depends on the model, labor on access. A coolant temperature sensor is often a few minutes' work. Sensors tucked under the intake manifold or in the gearbox need disassembly first. And a seized O2 sensor sometimes has to be heated before it'll come out.

Price

ServicePrice, GEL
Computer diagnosticsfrom 30
Sensor replacement (labor)from 65
O2 sensor replacement (labor)from 65
ABS sensor replacement (labor)from 59

FAQ

Can I use an aftermarket part?

For simple sensors, often yes. Aftermarket O2, MAF and crank units can be unreliable, though, so we'll tell you what works for your model. You can bring your own parts, but they carry no warranty. Parts we order come with a warranty — the manager will confirm the term. We can order parts for any car.

The code went away after replacement but came back. Why?

Most likely the cause was the wiring or something mechanical, and the part was never the problem. That's exactly why we check the circuit before replacing anything.

How much does replacement cost?

Labor from 65 GEL plus the part. You get the exact price after diagnostics.

How long does it take?

30-90 min for most sensors.

●  06 · Contact

Leave a request — we'll call back and book an inspection

Tell us what happened to the car. We'll call back, answer your questions and find a time. We give the exact price after an inspection: photos don't always show the damage.

By sending the request you accept the privacy policy.

Or message us — we reply right there:

Address
Airport Highway 212M, Batumi, Georgia
Phone / WhatsApp / Telegram
+995 599 66 66 75 · WhatsApp · Telegram
Directions
Google Maps ↗Yandex ↗Waze ↗
PRO SERVICE entrance