Clicking Noise When Turning: CV Joint, Strut Mount or Power Steering

Clicking Noise When Turning: CV Joint, Strut Mount or Power Steering

Updated: · PRO SERVICE

A clicking noise when turning under throttle, loudest with the wheel at full lock, points to the outer CV joint. Creaking or crunching when you turn the wheel standing still or at walking speed usually comes from the strut mount bearing. A hum or whine at full lock belongs to the power steering. You can tell them apart in ten minutes in an empty parking lot.

The empty parking lot test

Windows down, music off.

  1. Car stopped, turn the wheel lock to lock. Creaking or clicks from up top, near the strut tower: strut mount or spring.
  2. Turn to full lock and drive a circle with light throttle. A rhythmic clicking that speeds up as you go faster: outer CV joint.
  3. Hold the wheel at full lock for two or three seconds with the engine running. Hum or whine: power steering. Don't hold it longer, it's hard on the pump.
  4. Accelerate in a straight line. Vibration under throttle that goes away when you coast, or a clunk shifting between D and R: inner CV joint.

While a helper turns the wheel, put your palm on the top of the strut tower under the hood. You can feel a bad mount click through your hand.

Outer CV joint clicking when turning at full lock

Inside the joint, balls roll in grooves in the housing. Once the grease washes out or gets sand in it, the grooves pit, play develops, and the balls click under load. The sound is rhythmic, "click-click-click", clearest on a U-turn with some gas.

It almost always starts with the boot. The rubber cracks with age and heat or tears on a rock on a dirt road. Grease gets thrown onto the inside of the wheel and into the wheel well, and you see dark splatter. Water and sand get in, and Batumi's beach parking lots have plenty of sand.

Catch the boot before the click

If the boot tore recently and the joint is quiet, a new boot is enough: the joint comes off, gets cleaned, packed with fresh grease. That costs a lot less. Once the joint is clicking, a boot alone is too late, the joint is worn. So look at the boots any time the car is on a lift, an oil change for example. More on the job itself: CV joint and boot replacement.

Inner CV joint

It rarely clicks. Its symptoms are different: vibration under acceleration, a jerk pulling away, a clunk shifting between D and R. Inner boots tear too, and the grease ends up on the transmission and subframe.

Strut mount

On a MacPherson strut the upper mount holds a bearing that the whole strut and spring turn on. Humid salt air does its work: the bearing rusts and binds. Signs: creaking and crunching when you turn the wheel stopped or slow, heavy steering that's slow to return to center. Sometimes the spring jumps with a loud snap. A broken bottom coil on the spring crunches in a similar way, especially over bumps. Mounts usually get replaced together with the shocks, since the strut comes apart anyway.

Power steering and steering parts

Power steering doesn't click. It hums or whines, mostly at full lock. We covered that in power steering pump whining. A worn steering shaft U-joint clicks right in the wheel, tie rod ends knock. How to tell those from the rack is in steering rack knocking.

Tire rubbing the liner

Wider tires or wheels with a different offset can catch the fender liner or splash shield at full lock. That's a scuffing sound, you don't feel it in the wheel, and you'll see rub marks on the plastic.

Cheat sheet

SoundWhenLikely cause
Rhythmic clickingturning with gas, full lockouter CV joint
Creak or crunch up topturning parked or slowstrut mount, spring
Hum or whinewheel at lock, engine runningpower steering
Vibration or clunkaccelerating, shifting D to Rinner CV joint
Scuffingfull locktire rubbing liner

How long can you drive

A clicking CV joint won't fall apart tomorrow, but it won't last forever either. A joint that comes apart stops sending power to that wheel and the car loses drive. A creaky strut mount isn't dangerous right away. The steering just gets heavier while the bearing keeps falling apart.

What we check on the lift

We put the car on the lift and check the boots and joint play, the strut mounts, and the power steering fluid level and condition. A suspension inspection starts at 30 GEL.

FAQ

Do CV joints get replaced in pairs?

No, only the one that clicks. The other boot gets inspected though.

Can you replace just the outer joint and not the whole axle?

On most cars, yes, the outer joint is sold separately. A complete axle goes in when both joints are worn or the shaft is bent.

It's clicking again a month after a new boot. What went wrong?

The joint was already worn by then, or the dirt wasn't cleaned out. Sand in the grease chews up the grooves fast.

It crunches only for the first few minutes on a cold morning. What is it?

Usually the strut mount bearing: the grease in it has thickened and the race is rusty. It quiets down when it warms up, but the bearing is on its way out.

●  06 · Contact

Leave a request — we'll call back and book an inspection

Tell us what happened to the car. We'll call back, answer your questions and find a time. We give the exact price after an inspection: photos don't always show the damage.

By sending the request you accept the privacy policy.

Or message us — we reply right there:

Address
Airport Highway 212M, Batumi, Georgia
Phone / WhatsApp / Telegram
+995 599 66 66 75 · WhatsApp · Telegram
Directions
Google Maps ↗Yandex ↗Waze ↗
PRO SERVICE entrance